Axle Shaft

Axle Shaft

how much money is to replace an axle shaft bearing and seal? give me a close estimate?

In a 2000 Dodge Durango 5.9 4WD 116k, miles How many hours does it take to make this work?

$ 10 + mark - taking $ 30 + - I at home, no elevator, and from the deck of this has to go out, I want to do a full inspection there. I have four hours or more. if everything else is good. depends on your skill level. BTW, you can go to register http://www.autozone.com/ is free, enter your vehicle information, repair information goto / repairguide / is a Chilton / Haynes manual online clone. -------------------------------- - Here! c / w http://autozone.com "The following procedure is written for the withdrawal of an axis, but applies to both. 1.Raise and sustain safe vehicle safely on jackstands. 2.Ensure that the transmission is in Neutral. 3.Remove the wheel. 4.Remove the brake drum. 5.Clean all foreign materials from the top of the box area. 6.Loosen all screws box cover, and remove all but two bolts on top and two on bottom. 7.Use a prybar to pry cover loose from the shaft. 8.Allow gear oil drain housing. 9.Remove the top of the axle housing. 10.Rotate for the differential pinion mate shaft lock screw is accessible. Remove the locking screw. 11.Remove mate the pinion gear shaft of the differential housing. 12.Push the shaft to the center of the vehicle and remove the C-block slot in the shaft axis. 13.Pull out and remove the axle shaft. 14.Remove the axle shaft seal from the shaft end tube with a small prybar. NOTE Seal and bearing can be removed simultaneously with the removal tool bearings. 15.Remove axle bearings axle shaft tube using a suitable extractor. To install: NOTE Always install shaft seals are new. 16.Clean inside the axle housing, the removal of chips or foreign matter. Some units have a magnet at the base to catch metal filings. 17.Wipe shaft tube was clean. Remove any old sealer or burrs from the tube. 18.Install the axle shaft bearings. Sure that the part number carrying out. Verify that the bearing is installed straight and flush with the axle tube when fully seated. 19.Inspect shaft seal axle for spills or damage 20.Inspect roller surface in contact with the axle shaft for signs of brinelling, abrasions and stings. If any of these conditions, the axle shaft and / or bearing the seal and must be replaced. 21.Lubricate bearing and the seal lip with gear lubricant. Insert axle shaft through the seal, the course, and post it on the side gear splines. NOTE Be careful to avoid damaging the axle shaft splines lip shaft seal. 22.Insert locking C-clip on the end of the shaft axis. 23.Push axle shaft outward to seat locking C-clip arts side. 24.Insert pinion mate shaft into the differential case and through washers push and pinion gears. 25.Align the hole in the shaft with the hole in the differential case and install the lock screw with Loctite ® on the threads. Tighten the screw lock to 8 pounds / ft. (11 Nm). 26.Install lid and fill the differential gear oil. 27.Install the brake drum. 28.Install the wheel and tire vehicle 29.Lower .

Axle Shaft Removal